In our guide, you can learn why this happens and why you get the message from Wireshark, no interfaces found? By the end, you’ll see how you can fix the error when you try the following solutions below. A variety of factors could cause this issue. When Wireshark not finding “interfaces,” it’s referring to the fact that it couldn’t find any networks. You won’t be able to move on to the packet capture phase if Wireshark can’t find any networks at all. You must first choose one of these networks to capture network traffic packets.
The error message shows where you expect to see a list of accessible networks in the application window. If the program cannot find any networks attached to the computer on which it is operating during the initial scan, it will display the message “No interfaces found.” Wireshark searches the host computer for network connections at the end of its setup routines. My static ip adress on eth0 is so that I can connect in SSH directly via ethernet from my laptop, because I have no screen for my RaspberryPi.When you first start the open-source Wireshark to capture network packets on your computer, it goes through several post-initialization procedure steps. Source-directory /etc/network/interfaces.d
Here is my /etc/network/interfaces auto lo The default one on the Raspberry, and another one that I usually use for my computer, but I decided to give it a try. TX errors 0 dropped 0 overruns 0 carrier 0 collisions 0 I am currently trying to connect my Raspberry Pi 3 to Wifi, but the UI is telling me "No wireless interface found".
0 kommentar(er)
